Your cart is empty.
Your cart is empty.Product Description
Aluminum Adjustable Manual Turbo Boost Controller - Adjusting Intake Pressure
- Non Return Check Valve
Stops air from flowing back to the air pump or air compressor, keeping it in the line. Direction markings on the valve body clearly show the direction of airflow. Suitable for hose, PU tube, nylon tube
- Recommended pressure: 0~1.0Mpa
- Pneumatic Valve Body
Made of nickel-plated copper and PBT plastic material, with smooth surface, high hardness, high pressure resistance, anti-corrosion and long service life. There is a sealing ring inside, anti-leakage, strong sealing, safe to use
- Stainless Steel Card Spring
Clamp the air hose and make a good seal. Connected tightly, not easy to unbuckle, the gas pipe is firm and not loose, no air leakage, repeated pulling and inserting does not affect the card spring to tighten the strength
- Easy Connecting Air Tube
Press the valve cap, grab the air tube, slowly push it into the check valve fitting, the air tube will be locked by the spring washer.
- Note
When connecting the air tube to the check valve, make sure that the air tube is pushed tightly. This means that the air tube has passed through the sealing ring. If the air tube does not pass through the sealing ring, leakage or bursting may result
- Features
By adjusting the intake pressure, the adjustable manual turbo controller can increase the engine's air intake, thus improving engine performance and optimising the driving experience
- Application
Widely used in gas equipment, CNC machine tools, air lines, pneumatic tools, automatic assembly lines and other industrial equipment. Suitable for Most Turbocharged Petrol Diesel Engines
Turbo Installation Steps - Simple - Fast - Safe
- Allow the engine to cool down before installing the boost controller
- Locate the wastegate regulator ports and one pressure source port on both turbochargers
- If a boost control solenoid is installed, remove it from the boost pressure supply line
- Install the boost controller tee in the wastegate pressure line with the wastegate arrow pointing towards the wastegate regulator
- Then connect the the other end of the pressure reducing valve and make sure it seals well
- Adjust the screws at the top for commissioning
- It is recommended to use professional installation and good sealing work, to bring you a better feeling of use
$219.01
$ 99 .00 $99.00