Shopping Cart

Your cart is empty.

Your cart is empty.

1515-0469, 2 Rear Gas Shocks for Honda fits 2003-2005 Rincon 650 & 2006-2014 Rincon 680

Free shipping on orders over $29.99

$149.95

$ 63 .99 $63.99

In Stock

About this item

  • Manufactured by Factory Spec & Made in China
  • Aftermarket gas shocks provide upgrade over stock oil shocks. 10% stiffer springs provide a better ride and higher load capacity. Ready to mount out of the box, spring is already installed for quicker setup
  • Pre-load adjustable shocks are not rebuild-able. Available in black only
  • Sold as a pair
  • Replaces OEM#'s 52400-HN8-003 & 52400-HN8-A61


Compatible with Honda models below:
2003 Rincon 650 4x4
2004 Rincon 650 4x4
2004 Rincon 650 4x4 GPScape
2005 Rincon 650 4x4
2005 Rincon 650 4x4 GPScape
2006 Rincon 680 4x4
2006 Rincon 680 4x4 GPScape
2007 Rincon 680 4x4
2007 Rincon 680 4x4 GPScape
2008 Rincon 680 4x4
2008 Rincon 680 4x4 GPScape
2009 Rincon 680 4x4
2009 Rincon 680 4x4 GPScape
2010 Rincon 680 4x4
2011 Rincon 680 4x4
2012 Rincon 680 4x4
2013 Rincon 680 4x4
2014 Rincon 680 4x4


Kirk Dickinson
Reviewed in the United States on September 3, 2021
I broke the top off one of my shocks so decided to replace them both. The replacement shocks do not fit at all. If I were to use spring compressors, I could get them on, but they would be compressed 1-1/2 or 2" and the quad would ride terrible.
Paul C
Reviewed in the United States on August 12, 2021
I purchased these shocks for my 2003 Honda Rincon 650 which is listed as a supported model. My purchase was based off I went with the front shocks from the same company. The front shocks installed easily, seamless, and work great. My riding consists of trails, creek, and mud. From that experience I was excited for the rear shocks.Right out of the box, they were 1.5-2 inches longer than the stock shocks, which was not the case for the fronts. We went with a coil compressor figured it would work out for install along with adjusting the shock to make sure tension would fit decently. Thought was maybe I don't have to do a 2 inch lift ? Didn't work. There was so much strain on the back end the axles were not turning correctly. Remove the bronco's from the rear, put the old stock shocks in as they still worked, axles worked fine. Seller took the return no problem. No concerns with the seller at all, have been good to work with. They shipped quickly, I think the shocks arrived 1-2 days earlier than anticipated.My suggestion to the manufacturer: make these at least an inch smaller to fit the space in the rear of the quad without the degree of stress on the machine. If people go for these rears, you may need do some modifications to the shocks or quad to have them fit ideally.
David buckman
Reviewed in the United States on May 1, 2021
Was slightly longer than stock shocks. Little bit stiffer as well.
mark
Reviewed in the United States on February 12, 2021
rear shocks way to stiff had to disconnect and run without torsion bar ,,,, took all spring pre load off and still installation was a bitch. fronts are ok with no shock pre load,,
daniel halbardier
Reviewed in the United States on February 25, 2020
I have honda rincon 650and these shocks worked out perfectly i installed them and went on a trail ride. We rode most of the day I am normally sore after a day of riding but after this ride I was ready to go again the next day with no back painOne little tip before installing the shocks adjust them before putting them on on my bike there was not much room to get the adjustment wrench on the shocks
Steven B.
Reviewed in the United States on December 22, 2018
Worked great and reasonably priced