Your cart is empty.
Your cart is empty.Barbara A.
Reviewed in the United States on February 4, 2024
needed to repair some bids that where breaking these worked
Grazillda
Reviewed in the United States on February 18, 2024
These are much smaller than I expected. They are a bit hard to unclamp, but grip well and stay in place.
Mike L
Reviewed in the United States on November 8, 2024
Used to make bed sheet corner tie downs. These have a good tight grip and worked great for this purpose.
D. Egle
Reviewed in the United States on January 3, 2024
I ordered these to replace suspender grips that employed two plastic pads but didn't grasp cloth well enough to stay attached under normal usage. The ad showed a metal pin in the center of one of the plastic pads. However the grips I received did not have a metal pin on any of the twenty in the package.The second disappointment was that the metal attachment loop was very narrow and I had difficulty passing the suspender gripping components through the attachment loop.I have used these grips on a suspender pair for 1 day and they have stayed attached to the trousers. So, so far, the grips are working. Should they fail in the future I will update this review.
JoAnn Inchliffe
Reviewed in the United States on April 20, 2024
Just like the ones in the UK
Faith
Reviewed in the United States on September 13, 2023
Have not used yet but appear very strong
Jessica williams
Reviewed in the United States on April 28, 2022
works great for pacifer clips
AbbieCat
Reviewed in the United States on August 11, 2021
Saw a Bed Scrunchie here on Amazon for $35.99 that comes with eight clips, and more are super expensive. We purchasd these clips, pack of 20, for $6.99 and had some para cord laying around. My husband slightly bent the hole part into more of a gentle point in the center, so the cord didn't pull excessively on one side of the clip. We used 16, 4 per fitted sheet side, ran the cord through, put the sheet on the bed, and tightened it up, helping the cord a bit so the clips didn't pop off. Works like a charm for less than $10 vs. the $36 for the "system." Sheet is super tight and smooth.You need a fitted sheet that will go under the mattress all around. Look up Bed Scrunchie and watch the video. Then do it yourself. The eight clips included in that system are not enough, especially for a king bed, and it is really expensive to buy more. If the fitted sheet goes under the mattress, you don't need the velcro tabs that they have.We've tried so many sheet holders over the years and have been disappointed by all. Our homemade, diy sheet scrunchie works like a charm. Attach the clips (to the sides/ends, NOT corners, they'll pop off), run the cord, and tighten it up. Help feed the cord a bit as you tighten around the bed, so you don't pop off any clips. We have a massive footboard, so we elected to tighten from one side rather than the foot of the bed, and used a knot that can be released easily. It's a bit more effort to make the bed but totally worth it. We were tempted to bounce quarters off the tight sheets.
Recommended Products