Your cart is empty.
Your cart is empty. Description:
Frequency divider refers to the sound of different frequency bands are distinguished and amplified respectively, and then sent to the loudspeaker of the corresponding frequency band for playback. Electronic frequency division is required for high quality sound playback.
Feature:
1. Using special polypropylene (MKP) divider capacitance, original high power inductor and resistance.
2. The protector is also equipped with aluminum , which can provide sufficient heat dissipation and make the frequency divider last longer.
3. Frequency division point design in place, it is a rare high - grade power frequency division device.
4. Using the suellen firing grade MKP polypropylene film divider capacitance + line diameter up to 1.5mm ultra-thick bass inductor coil, ensuring its super large load power, long durability and good sound quality.
5. Enhanced high pitch of double neon bubbles can effectively reduce the high pitch damage rate.
6. Suitable for all 12-18 inch stage professional high power speakers on the market.
Spezifikations:
Type: Frequency Divider
Material: PCB
Power: 500W
Impedance: 4 ohms
Size: approx. 14.7 * 12.5 * 3.5 cm / 5.8 * 4.9 * 1.4 in
Weight: approx. 538 g
Package Include:
1 x 2-way Frequency Divider
Quintin Z Warner
Reviewed in the United States on February 12, 2025
I ordered one to test it . I'm running Rockfords with dual 16 ohm 15 inch woofers in parallel for 8 ohms and a high power tweeter. I'm pushing 500 watts into these and getting twice the volume out of the one I upgraded so I ordered another . The old crossovers were just resistors that looked like they been threw a fire. I converted the cabinets from 3 way to 2 way and probably put peavey horns in
Keon B. Billings
Reviewed in the United States on November 17, 2024
I know it’s not a picture of the crossover. But I already put the speakers in and I didn’t wanna bother taking it out just to show you a picture. What you should know is that those are two Dayton Audio pro woofers, and a Lavoce compression driver. I wired the system for 4 OHM load, connect it to a Behringer A800 amp, and my ears have been living a dream ever since. Whether I push them high, 400+ watts, or listen to them low and smooth, this crossover delivers beautiful sound. If I ever have another high-end project build like this, I will definitely get this exact model exact brand. It’s been working like a dream.
Jesse Gray
Reviewed in the United States on February 7, 2023
Quality parts and good 2-way crossover design. The wire gauge was heavy, parts firmly secured, soldering of the parts were good. Includes the on board lamp for the tweater protection that a lot of pro systems use, as it's such a simple protection method for tweaters/midranges. The lamp is replacable if needed without soldering. The capacitors and resisters are the right type to last forever. Amazon description doesn't say anthing about the crossover point at the time of my review but if you Google the model number, I found it stated as 2K (probably based on 8-ohm load) I would make sure your woofer specs cover up to that frequency at least, before the crossover to your horn/tweater.
SheaLyn Duymovic
Reviewed in the United States on September 16, 2022
No crossover point given wouldn't buy
Recommended Products
