Your cart is empty.
Your cart is empty.4 String Fretless Electric bass guitar neck Maple 20Fret 34Inch Rosewood fingerboard Nut 42mm Gloss Tuner hole 18mm . Nut width 42 mm.Heel width 63-64mm. Scale length 34inch. Truss Rod Adjust: Double Action Truss rod at Headstock or bottom 1x Neck Please note that stock photos are used. Each neck is unique in grain patterns. Variation of wood grains will vary from neck to neck.. thanks .
Lawrence Cugini
Reviewed in the United States on April 23, 2024
The truss rod is nearly impossible to move. It creaks miserably when turned in either direction and you'll strip an Allen wrench or two doing it. The paint is poorly applied and there are thin spots on the headstock. The tuner holes are not centered and are big enough to crawl through - get ready to do some wood working. I had to fill them with dowel wood and repaint, then re-drill at least 1/4" over. If I didn't, the heavy strings would all pull the nut toward your face, which wouldn't hold for long. Had to buy string trees. And the base of the neck is NOT Fender precision width. It's too wide. So you have to re-rout the body's neck pocket, as you wouldn't want to shave down the painted neck. Once installed, it's a bear to set up, but the tone is decent. The fingerboard feels good and has a punchy and resonant tonal quality. Honestly, this piece is way too much work just to save a few bucks.
Garth hamner
Reviewed in the United States on January 29, 2022
The only problem is the cheap plastic nut, but you can replace that for a few bucks and wood glue. I also didn't like the nitro coating. It was good quality, I just don't like it. I actually built a 5 string bass with this and it withstood the extra strain from that big B string. I will buy again for future builds.
Recommended Products
$54.99
$ 28 .99 $28.99
$83.98
$ 37 .99 $37.99