Your cart is empty.
Your cart is empty. #7 (DFE207RE) Red Dektite Square High Temperature Silicone Flexible Pipe Flashing
-Flashing Base is 18" by 18" - Pipe Boot Fits 6" to 12" Outside Pipe Diameter
-Continuous Service High Temperature Ranges of -58F to 392F (Silicone)
-If Trimmed and Installed Correctly, Pipe Flashing Will Not Break or Crack
-Use for Stove Pipes, Chimneys, Plumbing, Heating, Air Conditioning, Electrical, and Exhaust Vents
-20 Year Manufacturer's Warranty Against Manufacturing Defects
Works with Metal Roof Pitches up to 12/12 (0 to 45 degrees)
On a Roof with a 10/12 to 12/12 Pitch (45 Degrees) Dektite Recommends You Use a Square Base Pipe Flashing Installed With The Base Tip Pointed Towards Roof Top.When Used With Deep Ribbed Profile Roofing Panels With 1-1/2" Deep Corrugation Or More, Consider Using Next Size Up That Will Accommodate The Same Diameter Pipe
Manufacturers recommended temperature ranges are clearly stated. Please verify this product will meet specifications of your installation or possible product damage may occur
Ken R
Reviewed in the United States on January 11, 2025
metal is perfectly pliable. silicone is nice and soft
Klein Electrical
Reviewed in Canada on September 17, 2024
i bought this for my 6 inch insulated wood stove chimney its a perfect fit .
M. Tindall
Reviewed in the United States on May 31, 2024
Easy to install
Nelly
Reviewed in the United States on May 24, 2024
I made the mistake last time of getting the wrong type of silicone that wasn’t heat resistant and it ended up 🔥 . I also only uses a single wall chimney, which obviously did not work. But this go around I splurged and I haven’t had any issues. Really simple to use. Super satisfying to cut the ring. Just make sure you don’t cut too deep, right? You can always cut more, but you want that snug fit.
Calvin
Reviewed in Canada on March 3, 2024
Made chimney install easy in tiny cabin
bryan
Reviewed in the United States on February 27, 2024
Only works as good as you install it.Quality product
Customer
Reviewed in the United States on December 12, 2024
EASY TO INSTALL AND 100% WEATHERTIGHT WHEN INSTALLED CORRECTLY. COSTS A LITTLE MORE THAN COMPARED TO SOME OTHER OPTIONS BUT TOTALLY WORTH IT! VERY PLEASED
Lizz
Reviewed in Canada on November 16, 2024
Worked as expected. Easy install on a 12/12 metalRoof
Holland G.
Reviewed in Canada on November 3, 2023
The only thing I would have liked is there should be different pitches available so it's not tight on one side and loose on the other. I didn't see any available.
Samson
Reviewed in Canada on November 12, 2023
Great product. Was concerned about some previous reviews however the product worked great and fitted perfectly around my 6” insulated chimney pipe that had an outside dimension of 10” on a 10 / 12 pitch metal roof.
Kindle Customer
Reviewed in the United States on September 7, 2021
I bought two of these to seal my two chimneys after installing a new metal roof. The base is very easy to form to the ribs of the metal roof, and it has starter indentations for the screws. The graduations in the rubber are easy to see, and it cuts easily. I did use a caulk to seal the underside where it impacts the roof, but I am not sure it was necessary. The rubber fits very snuggly around the pipe. I have no issue with leaks. Great product,
Rodney R
Reviewed in the United States on November 29, 2020
I put on a corrugated metal roof on my house and originally received a round base type boot. It leaked the first rain because of the difficulty making the round base screw tightly down going over each corrugation. I used smaller square ones on vent pipe coming through the roof and they worked fine. So I bought this square base one on Amazon for my wood stove pipe. Installing the boot went on and secure a lot easier than the round one AND it worked great. No more leak.
Tim S
Reviewed in the United States on November 21, 2016
We installed a wood stove in our shipping container home this past weekend. We needed a rain stopper as with shipping container roofs there is not a slope to help with the rain runoff. We use a DuraVent triple-wall chimney and a DuraVent ceiling box on the inside. We cut the 10" diameter hole, inserted the chimney, and then worked on the roofing boot.This DekTite boot is incredible. I used a LocTite sealant around the chimney/hole and then used a silicon caulking under the rim. I used self-drilling screws in the container roof to mold the boot around our roof contours. I then used another bead of silicon caulking around the edge of the rim.Luckily, the boot was in place yesterday as the rain came last night. NO Leaking at all! Great Product!
Recommended Products
$281.17
$ 99 .00 $99.00