Your cart is empty.
Your cart is empty.An ACDelco GM Original Equipment Body Control Module is a GM-recommended replacement for your vehicle’s original component. It communicates with other systems in your vehicle to regulate electronic devices. This original equipment body control module has been manufactured to fit your GM vehicle, providing the same performance, durability, and service life you expect from General Motors.
Customer
Reviewed in the United States on September 28, 2023
I replaced the R.I.M. (Rear Integration Module) with this part on my 2001 Buick Lesabre and did not have to take it to the dealership to program. I followed some other tips from forums that suggested leaving the key on when you remove the old unit and remove the data plug first and then the power plug. You then plug in the new R.I.M. in the same order with the key still turned on. Everything started working immediately and even the remote keyless entry worked perfectly. I also did not bother to remove the seat back. I simply used zip ties to hang the new unit in front of the old and then taped the two together. I figured there was no reason to do all that if the dealer was going to need to take it out to program. Turns out it fits and I didn't have to do anything else.
Brent Blake
Reviewed in the United States on September 13, 2023
Worked just fine! Dealer installed and programmed.
Customer
Reviewed in the United States on November 2, 2023
Unplugged power wire connector, then data wire connector, and then when installing I plugged in the data wire first, and then the power wire and that avoided any necessary reprogramming of anything. Worked well too.
Liz Coram
Reviewed in the United States on December 24, 2021
Watched a YouTube and then ripped out the back seat on my 2000 Buick Lasabre to replace this GM module. Now my power trunk, door locks, heated seats, interior lights, reverse lights etc. all work again!! Have to remove the back seat to get to those 2 small plastic screws, unreal GM, just a horrible design. All else can easily be done from inside truck.
BM from Boston
Reviewed in the United States on November 4, 2018
Worked great, easy to replace.Hint: if you replace, with the key in the on position, you may not need the have the key reprogrammed by GM (+$100). just remove the data cable first, before removing the power cable. After install put the data cable first then power cable, it should see the key in the ignition. This worked for me.
KURT45COLT
Reviewed in the United States on October 16, 2015
WORKS GREAT SO FAR
Recommended Products
