Your cart is empty.
Your cart is empty.This Stage 2 cold air intake system produces 12 horsepower, 13lb. x ft. torque and outflows the factory intake by 73 percentage. Enclosed in a durable 16 gauge, powder-coated heat shield; this air intake system features a washable/reusable conical air filter that improves airflow for increased horsepower and torque. This intake system also features a 2 piece wrinkle black powder-coated tube design that replaces the stock intake tract and directs increased air flow with improved volumetric efficiency for maximum performance. One-piece heat shield requires no assembly and the filter is constructed with 100 percentage polyurethane for long life and multiple cleaning cycles.
Do not start the party
Reviewed in the United States on July 26, 2015
it took me about 4 hour to install. i have very little backround in this field. I feel a man should restore a car once in his life. well i am not going to that i am willng to DYI a car.So i pick this job. it was 4 hour job. the directions are ok. i went on KN you tube channel where i got stuck. All the hole match up perfectly. the problems i had was not with air flow system but Jeep. I could not find the ratchet for the bolts, plus rods was rusty. it took me about 90 mins to take off one bolt..i could not remove the air temp sensor out... Im just buying a new one..i drove the car round block.. So far it faster.. and little bit louder...side note i am 5'10 i had to use a ladder to get some parts...
michael cimino
Reviewed in the United States on February 9, 2015
Definately improved horsepower. Gas mileage stayed about the same, easy install, sounds mean.
Nigel R Sylvester
Reviewed in the United States on April 30, 2015
Perfect fit the instructions could be a little more detailed but enough to complete the install
Recommended Products
$442.03
$ 99 .00 $99.00