Your cart is empty.
Your cart is empty. Replacement keypad for the 5 key Dynamic Shark DK-REMD11 joystick remote. The 5-key Dynamic Shark is used on the Jazzy 614 and several PaceSaver power chair models. This part is sometimes referred to as a joystick overlay.
Also used on the Invacare MK5 SPJ "with accessories" joysticks.
Installation Instructions:
1. Ensure the wheelchair power is turned off.
2. Pull the gray collar back and disconnect the joystick cable from the joystick.
3. Peel up and remove the existing, damaged keypad from the joystick face plate.
4. Inspect the joystick contacts, face plate, and joystick housing for corrosion and/or damage.
5. Using an alcohol pad, remove any adhesive from the joystick face plate.
6. Ensure no adhesive remains around the rim of the joystick face plate.
7. Gently remove any adhesive that may have collected in the lighting or contact cutouts of the joystick face plate.
8. After cleaning, set the joystick aside for ten minutes to allow all alcohol to evaporate from the joystick face plate.
9. Remove the backing from the new keypad.
10. Align the bottom edge of the keypad with the bottom edge of the joystick face plate. Ensure the keypad is properly aligned with the joystick face plate before installing. The overlay is not repositionable.
11. Working from the bottom up, gently press the keypad completely into the joystick face plate.
12. Firmly press the keypad into the joystick face plate ensuring proper seal between the adhesive and joystick face plate.
13. Connect the joystick cable to the joystick.
14. Turn on wheelchair power and test the joystick functions.
Glenda R.
Reviewed in the United States on December 18, 2019
I bought it because all my lights for the battery did not shine but that didn’t fix the problem so I’ll guess I’ll just live with it and hope that the battery Doesn’t run down without me realizing it
Recommended Products
