Your cart is empty.
Your cart is empty. Brand New 4WD Front Differential Axle Disconnect Assembly With 4WD Actuator
Made In The USA
Axle Disconnect Is Also Called Intermediate Shaft Bearing Assembly
Upgraded Design Uses Synthetic Grease For Long Trouble Free Life
For AWD (All-Wheel Drive) Models See APDTY 711227
If You Need The Intermediate Axle Shaft, See APDTY 112658
Match Vehicle To Compatibility Chart To Ensure Exact Fitment
Compatible With 2002-2009 Chevrolet Trailblazer 4WD (Except AWD)
Compatible With 2002-2009 GMC Envoy 4WD (Except AWD)
Compatible With 2003-2008 Isuzu Ascender 4WD (Except AWD)
Compatible With 2002-2004 Olds Bravada (Except AWD)
Replaces OEM: 15884292 & 12471631, 12479081, 12471629, 12471631, 12471627, 12471624, 12479132, 12479302
⚠ California Proposition 65 WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
alex
Reviewed in the United States on February 13, 2024
Actuator was broken. Had to use the old one from vehicle to make it work
Jeff L Draney
Reviewed in the United States on August 8, 2023
Quality looks good, A lot cheaper than OEM. I got 238,000 miles on the original. Hope this lasts half as long.
Stoic Customer
Reviewed in the United States on March 8, 2020
Fit like a glove. Had difficulity finding one locally. Delivered in 2 days
Jeremy P.
Reviewed in the United States on December 19, 2020
The disconnect worked fine but the actuator made noise like it was working but didn't have enough power to engage the 4 wheel drive. I ended up buying a new transfer case switch thinking that it was bad after installing this product. One good thing is that all the switches and actuators are new but spend to much time and money because of a new defective actuator. A person would think after reading the reviews on this product that this company would put a better quality actuator on this unit.
Customer
Reviewed in the United States on March 10, 2019
Great product - fit could not be better. Original GM one was 14 years old, grease failed, bearings gone. This was a 100% drop in replacement. Best part was the install was so easy. Just purchase a new CV axle at the same time to go with this new part so the seals have a clean and new seat to run on. YES I would purchase again. Amazon is less then the small box auto supply stores! Good luck with yours... check out U Tube for videos on how to install. Thanks to Amazon on next day delivery! Install was less than 2 hours!
Joel Lopez
Reviewed in the United States on November 25, 2018
Worked like a champ, complete bearing assembly with housing at a fraction of the OEM cost.
Byk
Reviewed in the United States on July 19, 2017
went right in and we tried the 4wd when it was still on the lift it did engage the front wheels. now I just have to see how it is in the long term.
Fermundy
Reviewed in the United States on March 26, 2017
My 07 trailblazer that I recently bought had a grinding noise all the time and was told it was the bearings and I trusted them but later found out the 4x4 wouldn't engage. Found this part was bad and replaced with the new one and it fixed the noise and the 4x4 with the addition of an axle shaft because the splines were stripped out on both parts... it works wonderful now!
Recommended Products
