Your cart is empty.
Your cart is empty.Product Description
- GM LS / LT (Gen III, IV, V)
- Transmission to Engine
- M10-1.5 x 1.750 in. UHL
- Grade 10.9 Hardened Steel
- Clear Zinc Plated
- Set of 8
Fits all GM automatic and manual transmissions that are bolted to an LS / LT (Gen III, IV, V)
Michael Case
Reviewed in the United States on December 6, 2023
They are not 1.750” UHL (Under head length)They measure 1.3” UHL. Too short for my application.
Rubidoux951
Reviewed in the United States on December 17, 2023
Had a new transmission installed in my Yukon and went ahead and got new bolts and reused the stud type bolt that the truck came with already but work as described will buy again if I have to do a new transmission swap4L65E
Customer
Reviewed in the United States on December 10, 2022
Great fit
Tina O.
Reviewed in the United States on June 24, 2020
i used on a 2002 trailblazer 4l60e transmission i was very happy to order from you will order again
jesse carpenter
Reviewed in the United States on December 8, 2020
Twice I've ordered and sent 3 starter bolts
anasynpunk
Reviewed in the United States on September 3, 2019
After my fourth transmission change in my supercharged, cammed, methanol injected 02 Silverado I decided it was time to get new hardware as some of the originals were starting to round off slightly...if you've pulled one of these transmissions you'll know that some of the bolts are difficult to reach leading to the mentioned rounding. I gave them four stars only because this set would have perfect if it had included two stud type bolts in lieu of a complete set of hex bolts. Otherwise, they were exactly what I needed!
Nedio Vivola
Reviewed in the United States on May 4, 2019
Good Match
Recommended Products