Your cart is empty.
Your cart is empty.Belltech Drop Spindles offer various drop amounts depending on your application, while improving handling and retaining factory ride quality. Belltech spindles maintain critical suspension geometry and eliminate excessive ball joint, shock and tire wear common to other methods of lowering. Each spindle is crafted from powdercoated, CNC machined, high strength ductile iron castings providing the structural integrity to meet and exceed all factory specifications & requirements. These spindles will increase the track width of your vehicle by approximately .45" per side. These were developed to allow the fitment of small diameter wheels (15" - 16") that were popular at the time of inception. Please make sure you are aware of this increase in track width before you purchase these lowering spindles
Dan Boudreau
Reviewed in Canada on April 22, 2023
The spindle shaft to short I can't even put the castle nut far enough for the cotterpin to fit in the hole .The original shaft measures 4 3/8 And the drop spindles measure 4 inches now I'm screwed not happy
Melanie
Reviewed in Canada on September 29, 2022
Fit perfectly on my 80 c10 I just had to bend the flew hoses to clear the control arm . For use with 1.25" not 1"rotors.
Sandman77
Reviewed in the United States on March 20, 2022
They like they're supposed to and would have give a 5 star review but they failed to mention that you need to buy a set of heavy duty rotors for them. I bought the drop spindles for the 1" rotors not 1-1/4" rotors
M
Reviewed in the United States on May 7, 2021
Works well just expect to trim control arms if using stock arms. Gave me the ride height I was looking for for my C10
armando
Reviewed in Mexico on May 22, 2021
Llego muy bien, en su caja de madera bien protegido, se siente de buena calidad y cumple su función
Mel
Reviewed in the United States on September 8, 2020
The Belltech spindles went on fine however, I did have to modify the caliper because I replaced the breaklines and the big bolt on the bottom of the spindle was in the way of the breakline.These spindles were installed on a 1977 Chevy C10 pickup
jaycoll
Reviewed in the United States on May 26, 2019
Installed on my 90 suburban 2x4 1500.....Easy install make sure your rims are 18 or bigger.My rims are 17 I had to use 1/4 inch wheel spacers if I had not ...when turning the wheel it would scrubb the inside of lower control arm
Christopher Ramos
Reviewed in the United States on December 27, 2019
Great product for my 1985 C10.
Customer
Reviewed in the United States on October 2, 2019
The spindles worked great on my application
Chris Miles
Reviewed in the United States on October 26, 2018
as advertised
A.L.G.
Reviewed in the United States on December 12, 2012
WHAT CAN I SAY BELLTECH IS THE BEST AND GOES IN EASY IT TOOK TWO OF US AN HOUR TO PUT THESE IN AND 1 INCH DROP SPRINGS
Recommended Products
$43.04
$ 21 .99 $21.99