Your cart is empty.
Your cart is empty.A C. B. Gitty Crafter Supply Exclusive: the "Cap-o-Tone" Junior pre-wired disk piezo harness for cigar box guitars and more! This harness does not include printed instructions - be sure to check out the How-to-Install info below to get an idea of how to use this harness in your cigar box guitar! This is a great pre-wired piezo pickup, perfect for mounting in your cigar box guitar! The piezo disk is carefully mounted into the bottle cap with a cushioning adhesive, which helps insulates and helps tone down the high-end of the piezo disk to reduce feedback and give you a nice, mellow tone. The jack is a premium Neutrik long-shaft mono jack, great for getting through thicker cigar box walls (though some thinning on the inside of the box may be necessary with thicker-walled boxes). Unlike the Cap-o-Tone Standard model, this harness does not include a volume pot, so this one is a bit simpler and easier to install. The pickup comes with a piece of high-strength double-sided adhesive tape for mounting, though you may want to take additional steps to secure it if you think your CBG will be knocked around a lot. Every harness is carefully tested in the C. B. Gitty shop before being packaged and shipped to you. There have been a lot of folks making bottlecap piezo pickup harnesses over the years... give ours a try and find out more and more CBG builders are saying: Make mine a Gitty! Usage Instructions Introduction and Usage Overview This pre-wired, no-solder pickup harness is intended to be used in cigar box guitars and other handmade/homemade instruments. High-quality parts and craftsmanship have been used in the creation of this harness, and each one is fully tested before being packaged and shipped. These harnesses are designed for ease of install and long-term functionality. We also have a variety of other pickups at C. B. Gitty Crafter Supply, if you are looking for more options.
Larry Stutz
Reviewed in the United States on June 13, 2020
Cigarbox guitar.
Recommended Products
