Your cart is empty.
Your cart is empty. #3 (DF203RE) RED Round High Temp Silicone Flexible Pipe Flashing
Flashing Base Diameter is 8" - Fits 1/4" to 5" Outside Pipe Diameter
Continuous Service High Temperature Ranges of -58F to 392F (Silicone)
If Trimmed and Installed Correctly, Pipe Flashing Will Not Break or Crack
Use for Stove Pipes, Chimneys, Plumbing, Heating, Air Conditioning, Electrical, and Exhaust Vents
20 Year Manufacturer's Warranty Against Manufacturing Defects
On a Roof with a 10/12 to 12/12 Pitch Dektite Recommends You Use a Square Base Pipe Flashing Installed With The Base Tip Pointed Towards Roof Top.
When Used With Deep Ribbed Profile Roofing Panels With 1-1/2" Deep Corrugation Or More, Consider Using Next Size Up That Will Accommodate The Same Diameter Pipe
Manufacturers Recommended Temperature Ranges Are Clearly Stated Please Verify This Product Will Meet Specifications Of Your Installation Or Possible Product Damage May Occur
William V.
Reviewed in Canada on September 7, 2024
Lasted about 2 years and 10 fires . Worked good but was cracked all over with in 2 years .
J. Tremblay
Reviewed in Canada on July 20, 2021
Easy to installand use
Customer
Reviewed in Canada on May 16, 2021
Like did the job perfectly
Martha J. Fuller
Reviewed in the United States on May 10, 2020
Product was great...very easy to install...perfect for our project
S B
Reviewed in the United States on February 21, 2020
It fit great like a glove went right over the metal siding no leaks
Glenn Jones
Reviewed in Canada on October 16, 2020
Seems like good quality and it came very quickly. I haven't installed it yet but looks simple enough.
Customer
Reviewed in the United States on January 9, 2020
Work like it should, fairly easy to install
Alexander Schump
Reviewed in the United States on January 5, 2020
I used this as a stove jack for an Ozark Ttail teepee tent. Get a spark arrestor. I used superglue to glue it to the hole I made in the wall fabrique. I'd suggest making the hole after you glue it onto the fabrique when it's laid out flat. Then cut the hole when the glue has dried.Its not the proper usage of this thing but it was able to withstand the heat from a single walled tent stove pipe so chances are you're good to go with this.Also, don't let the pipe touch flat to the red silicon... It will bubble it if you get the stove any kind of hot relative to it's normal operating temp.
Kellye Johnson
Reviewed in the United States on September 26, 2019
Just had a metal roof put on and our guy we hired to put the roof on didn't use the correct boot for our pellet stove and I didn't want a fire ,so I ordered this boot for high heat temperatures and I believe it's will work great .
S.D.
Reviewed in Canada on July 12, 2019
works very well and is light and flexible so slight angles not a problem
Steve
Reviewed in the United States on June 19, 2019
It was a bit hard to install, but that might be because I was installing it in a school bus roof, and the roof is curved. I had very little room to screw in the bottom little lip. I wish I'd gone a size bigger than recommended. But, nevertheless, with lots of heat-resistant caulk stuff, it got installed and has stood up to weather, a few fires, and traveling down the road at 70mph for 20 hours. What more can you ask for?
Badger31738
Reviewed in the United States on April 29, 2019
I thought it came with two metal rings. One for the front and one for the inside of the rubber section. It didn’t, so I wasn’t able to use since I couldn’t seal the edges. Couldn’t return since I already cut to size. What a waste of money.
Sasha
Reviewed in the United States on January 28, 2014
I installed the dektite boot on an rv where I installed a marine small wood stove. I used 3" double wall pellet stove pipe and ran the pipe through the boot, about 5' from stove. The pipe gets very hot, and the boot gets warm, but with about 30 firings so far-it has not caused any issues and has performed as it the description said it would. The only issue I had with ordering this through an outside company through Amazon. Amazon's delivery date and the companies delivery date were off by a week, so I ended up waiting a lot longer for it.
Recommended Products
