Your cart is empty.
Your cart is empty.Fits 2" OD aluminum dock post with either thick or thin wall. 1.725 ID or 1.790 ID, Will not break like some poor quality off-shore manufactured cast augers, Made in the USA from MILITARY GRADE composite materials, Auger is perfect for a freestanding dock system to help anchor and stabilize, Ideally suited for sand, clay, mud or small stone lake bottoms. If using to make sand anchors with standard PVC tubing they fit sloppy into 2" tubing. 1.5" tubing needs to be heated so that it can expand when pushing the auger in
James
Reviewed in the United States on June 18, 2024
I bought 30 of these. About half price or less of metal onesThese worked great for my dock through muck, sand and small rocksI used metal ones in the past but the price brought me to these. They are everybody as good as metal. Some of my poles are 4' plus in the water. So much lighter then jagged metal ones. Great product
Andy S.
Reviewed in the United States on December 1, 2024
I had to use a belt sander to get these to fit inside 11/2" schedule 80 PVC. Once fitted, they work fine.
Tom Shimko
Reviewed in the United States on July 18, 2023
Easy to use and install
SW 1966
Reviewed in the United States on July 26, 2022
Good low cost alternative to cast aluminum….worked well on the gravel lake bed so should do fine on sand also.
leo
Reviewed in the United States on October 9, 2021
Easy assembly.. used 1.5 id.. pvc pipe.. heated it up. Stretched right up and used a ss hose clamp..
Daniel
Reviewed in the United States on September 30, 2020
Engineered to the highest standard. This product is fantastic. Anchors well into sand and rocks. Fast ship and reasonably priced.
DDDish
Reviewed in the United States on October 20, 2020
The construction seems fine, but i cant find a tight enough PVC to use it,1.5" same OD, and2" ID is too lose,sced 80 2" is a little better, but still not snug, what size pipe is it suppose to fit into?
DPUC
Reviewed in the United States on July 24, 2017
I make my own bot anchor auger poles and until finding these high strength plastic auger I have used galvanized which are good as well just heavier and pose a hazard to your boat if not handled with care when storing or extracting. The plastic auger is much lighter and safer when bumped against your gel coat or glass deck, hull, etc. I install these using a 2" sch 40 PVC pipe and you will need to file the insert portion of the auger to fit the ID of the pipe but using a bench grinder it was fairly easy to achieve.
Recommended Products
