Your cart is empty.
Your cart is empty.adam stewart
Reviewed in the United States on March 11, 2025
Hardware that comes with this item is junk quality, the welds interfere with the bolt head or the washer depending on witch way you put them through from being able to sit flat against the mounting plate.
Aliviana York 2.0
Reviewed in the United States on August 10, 2024
The Hermit Sez,I got this to replace the Pintle Hitch on a heavy equipment trailer. I just got tired of the clanking, slamming, and banging of the Pintle Loop it's totally unnecessary and annoying.This Hitch is fully welded inside and out, to the flat plate and looks like a very well made piece.The release lever is spring loaded, so it must be completely raised up and secured with a hitch pin while the tounge is lowered onto the ball. I have found it to be a bit difficult to release if there is a load on the trailer.I have a system that I won't go into detail about here for safety reasons, for releasing the ball from the hitch, that requires the tounge to be jacked up, while the truck is in neutral with the brakes released.Overall the hitch works and I have confidence in it.I Hope My Review And Pictures Were Helpful To You !!
Ryan E.
Reviewed in the United States on February 25, 2024
Came with bolts etc. and pattern was correct to just unbolt pintle and swap it in 5 minutes tops.
Clayton
Reviewed in the United States on October 2, 2024
i got this for my equipment trailer, because it had a pintle hitch on it before, and the pintle was making a lot of noise going down the road. this installed in minutes, and is so much quieter.
Recommended Products