Your cart is empty.
Your cart is empty.HONDA PIONEER 700 ACCESSORY SUB HARNESS 08Z02-HL3-A00
Tommy Barnett
Reviewed in the United States on December 3, 2023
Sub harness does not fit the 23 Honda Pioneer.
M. Talbott
Reviewed in the United States on March 8, 2022
I installed this harness on a 2021 Pioneer 700-4D. There are no instructions at all. Anywhere. Based on the connectors you’d think you just find similar connectors in the front compartment and plug them into the harness. Nope. There’s a green connector on this harness that doesn’t match anything in the front compartment. I ended up cutting that off and splicing it into the two wires that come out of the main harness and feed the accessory (cigarette lighter plug) port. After that it was plug and play. Of course I had to do some tracing to figure out what went where. Don’t buy this if you don’t know what you’re doing with 12v electrical. It may be plug and play on some model(s) but my model was listed as a fit and it did not fit out of the box. Honda dropped the ball on this.
john ervin
Reviewed in the United States on July 11, 2021
Does what it should. Plugged right in, used for reverse lights on my 2021 honda pioneer 700 deluxe.
D
Reviewed in the United States on March 10, 2021
This plugged in to the factory harness on my 2021 Pioneer 700D. Difficult to determine what wiring harnesses will fit the 2021 700's from all the reviews, comments, etc., but this one worked perfectly!
Tina J. Pinar
Reviewed in the United States on February 22, 2021
part came on time direct replacement worked excellent for my needs
Ed B
Reviewed in the United States on August 27, 2020
Saved me from cutting into my harness. Plugged in as advertised.
Gina Pruitt
Reviewed in the United States on May 19, 2020
Easy to install. Made winch hookup to "key on" power simple.
Bruce C.
Reviewed in the United States on April 4, 2017
Just installed it last night. Instructions would have been nice.First remove the "hood" and look at the firewall. You have to unplug the black plug from the back of the power socket (cigarette lighter plug) and the green plug that's in the center (just back trace the wire). Then plug the black connector of the new harness onto the back of the power socket and the green to the green connector you just unplugged the old harness from. I couldn't get the plastic anchor to let me remove the old wiring, so it's still in there. The important things to note are the new wires sticking out. The white with black stripe is 12 VDC + (two of them) and the green is 12 VDC - (one male plug). Attach your new devices to the harness for key switched power. Be careful total draw doesn't exceed 10 amps or you'll blow a fuse. If you up-size the fuse, you'll melt wires. Relays are your friends.
Recommended Products
$66.95
$ 28 .99 $28.99