Shopping Cart

Your cart is empty.

Your cart is empty.

Humminbird 710275-1 XP 9 HW - HELIX Dual Spectrum CHIRP In-Hull Transducer

4.3 (9) Write Review
Free shipping on orders over $29.99

$96.05

$ 43 .99 $43.99

In Stock

About this item

  • Compatible with: HELIX 5 CHIRP G2/G3 – GPS-equipped models only, HELIX 7 CHIRP G2/G3/G4 – GPS-equipped and CHIRP DI G2 models, HELIX 7 CHIRP G2N/G3N/G4N – All models, HELIX 8 CHIRP G3N/ G4N – All models, HELIX 9 CHIRP G2N/G3N/G4N – All models, HELIX 10 CHIRP G2N/G3N/G4N – All models, HELIX 12 CHIRP G2N/G3N/G4N – All models, ICE HELIX CHIRP G2/G3 and newer – All models (in Open Water Mode) Side Imaging and Down Imaging units can support this transducer as a 2D sonar only transducer.
  • Cable Length: 15 Feet
  • Side Imaging and Down Imaging units can support the XP 9 HW as a 2D sonar only transducer. This transducerdoes not support Side Imaging or Down Imaging.
  • Dual Spectrum CHIRP Frequencies: Full: 150-220 kHz, Narrow: 180-240 kHz, Wide: 140-200 kHz
  • Dual Spectrum CHRIP Max Depth: 1200ft (365m)
  • 1-Year Limited Warranty


In Hull Dual Spectrum CHIRP 2D Sonar with high frequency beam and wide cone angle, offering CHIRP range of 150-220kHz and max depth of 1200ft. For use in single layer fiberglass hull. No temperature


Odell
Reviewed in the United States on April 30, 2024
It was what was ordered.
John Quinn
Reviewed in the United States on March 21, 2023
Added to inside of my hull for my Helix 7 to read at high speeds. Must buy a y connector to use 2 transducers.
PC
Reviewed in the United States on December 27, 2023
Came on time
Bernie D.
Reviewed in the United States on November 11, 2023
Item as described, time!y delivery.
gbaylies11
Reviewed in the United States on October 1, 2023
They have pretty thick hulls and it worked perfect!
Russ cook
Reviewed in the United Kingdom on March 2, 2021
Yes. It is a through hull transducer.Unfortunately. When used as such does not support all of the features in my helix 7 fish finder. Not mentioned in the listing.
chris
Reviewed in the United States on July 13, 2020
ALTHOUGH THE UNIT WAS DEFECTIVE, HUMMINGBIRD HELPED THROUGH THE TROUBLESHOOTING PROCESS AND ORDERED A NEW TRANSDUCER FOR ME. 100% PRODUCT ON SUPPORT. THEY BACK THE'RE PRODUCT. .
MrFixIt
Reviewed in the United States on December 16, 2020
I am using this with a Humminbird Helix 5 fishfinder/GPS/chartplotter. This was installed into the hull of a 2016 Yamaha VX Cruiser waverunner. I glued it in about 4" aft of the fuel tank, on the V-hull centerline. The transducer comes with a perfectly thickened, white 2 part epoxy (in a pouch). In my application, the transducer was not flush against the hull as I elected to bridge the internal "V" of the centerline (so I would truly be shooting straight down), so I relied on the thickened epoxy to fill that area in solidly between transducer face and hull. While I would have felt better with a little more epoxy being supplied, what was supplied was adequate and did not run while setting up. I let it set for 24 hours before use. My waverunner tops out at 54mph and I get accurate bottom readings even at that speed, which is remarkable for an application like mine. Very happy so far.
Steve
Reviewed in the United States on December 26, 2019
Worked perfectly to fix high speed issue with humminbird helix 7 loosing depth readings. Wish I had installed sooner.