Your cart is empty.
Your cart is empty. IDC-20 Interface Module with Simple DIN Rail Mounting feet.
IDC pin pitch 2.54mm/0.1" male header connector.
Pitch 3.81mm/0.15" screw terminal block.
Sample DIN Adapters (Feet): for width 35 / 32 / 15mm DIN rails.
FR-4 fiber glass PCB, dual copper layers.
PCB dimensions: 51 x 70mm(L x W).
100% new, never used.
Rated voltage: 60V.
Rated current: 1A / per pin.
Operating Temperature: -20ºC to 50ºC
Terminal block specifications:
Wire range - 26-16AWG.
Strip length - 5mm.
Screws - M2,steel,Cr3+ Zn plated.
Torque - 0.2Nm (1.7Lb-In.).
Pin header and Cage - Brass.
i.am.ericc
Reviewed in the United States on October 25, 2024
Needed this to change the pinout of a data ribbon and it performed the job excellently.
Rickey M. Horwitz
Reviewed in the United States on June 11, 2022
This break-out board works as advertised. However, the wire binding posts are small and only accept smaller gauge wire. The compact design prevents installing or removing ferruled wire installed on the lower block. Silkscreen of pin designators are clearly printed. Overall, the quality is good.
Antoniozx
Reviewed in the United States on February 7, 2022
Thi as item works and could be a good breakout boards... i purchased 8 pieces and 3 pieces has issues with pin out no 5.. there is no continuity between out soldered side and pin out connection..... these board may not be properly tested for QC issues...
Steve Leonard
Reviewed in the United States on February 23, 2020
I used this to wire up the output of my PLC DC Output card to a bank of 16 relays. Now I’m able to use these relays for higher voltage/current applications. This will allow my controller to be isolated from all the equipment it controls as well.
BRUCE H.
Reviewed in the United States on August 3, 2019
Providing the mounting brackets was very useful.
Adam Roth
Reviewed in the United States on April 8, 2019
Connected this board to a capacitive touch led screen via a ribbon cable in prototyping stages. Would have been miserable wiring everything without this breakout board
Greg Powers
Reviewed in the United States on October 19, 2018
This breakout device made my project prototyping much easier. The screw connectors make attaching and removing wires a snap. It would be almost impossible to work with the 20 wide flat cable without this breakout board.
Recommended Products
$23.99
$ 11 .99 $11.99