Shopping Cart

Your cart is empty.

Your cart is empty.

Litolevel Tile Leveling System/Spacer System Replacement Spacer Bases (500-Count) 1/16' (1,5mm)

5.0 (3) Write Review
Free shipping on orders over $29.99

$43.66

$ 19 .99 $19.99

In Stock

1.Size:Spacer Base - 250 Pcs


  • Suitable for various tiles (ceramic, natural stone tiles, stone slabs, large porcelain panels, etc.)
  • Designed to level tiles with a thickness range of 1/8"-1/2", and creating narrow joints of 1/16". Creating joints wider than 1/16", with the purchase of our tile spacers in the preferred size
  • Great for DIY projects, first time, as well as professional installers
  • Easy 3-part system. Base that is inserted under tile, Cone (reusable) that you place over the base like a ring, and the Nut (reusable) that tightens onto base by screwing on using vertical pressure that allows the installer to control tightness and/or make adjustments without horizontally shifting the tiles, thus ruining tile alignment
  • Unlike fully reusable leveling systems you do not need to go back and remove while adhesive is still wet and then have your tiles shift. With Litolevel leave system in place until adhesive is fully set insuring tiles will not shift


Litolevel guarantees a perfectly leveled, simple and fast tile laying system, eliminating lippage between tiles. The most affordable 3 part non-friction system, ensures that your tiles do not shift out of place when installing or removing. Our system is great for creating narrow and wider joints alike, and laying tiles that are 1/8"-1/2" thick. For removal; once adhesive has completely dried, unscrew the nut and cone. The top of the base will then be exposed, and simply break base using a rubber mallet, or your foot. Just be sure to strike mallet in direction of the tile joint line.


Kindle Customer
Reviewed in the United States on January 29, 2022
At keeping tiles flush.
Joe
Reviewed in the United States on May 9, 2021
I used these for the first time on 18 in. x 18 in. Travertine floor tile that is 1/2 in. thick. Worked very very well as it eliminated lippage. Absolutely no mess neither. I never had to remove a tile so long as you have even thin-set coverage and your floor is very level; which mine was. The devices held up well. Not a one broke as I thought they might when tightening. What I did was lay a whole course with the floor spacers in between including along the side where the 2nd course goes, too. Then, install the cones and screws and tighten until the lippage is gone.. I then added slight pressure on two adjacent tiles with my hands going back-and-forth to ensure good thin-set coverage but not too much pressure that you go beyond the level of the next tile. Each time I added pressure I tightened the screw. Use a four or six-foot level to make sure the tiles are level throughout the course. Lucky for me and because I took my time slowly adding pressure and frequently tightening the screws, I had a perfectly level tile floor. Just because you’ve eliminated lippage doesn’t guarantee a level floor.
David Taing
Reviewed in the United States on November 12, 2019
floor ok but not for wall due to 3 pieces trying doing one thing at same time takingtoo long looking for pieces to fit together.