Shopping Cart

Your cart is empty.

Your cart is empty.

Makita HR5000 2'' Rotary Hammer, accepts Spline bits

5.0 (7) Write Review
Free shipping on orders over $29.99

$1,199.00

$ 99 .00 $99.00

In Stock

About this item

  • All ball-and-needle bearing construction for longer tool life
  • Powerful 11 AMP motor delivers 2,100 BPM for the most demanding applications
  • Built-in clutch reduces gear damage by disengaging gears if the bit binds
  • 2-mode operation for "Hammering Only" or "Hammering with Rotation" for multiple applications
  • Sequential impact timing delivers timed hammering during rotation to minimize overlapping bit impacts resulting in up to 50% faster drilling


Value-priced, high quality tools - leading the market by ensuring that products are rugged, reliable and reasonably priced.


Monica Malone
Reviewed in the United States on June 6, 2018
tool is new but hard to get the right bits for it. However, it hammer drills just as expected.
k w
Reviewed in the United States on July 6, 2016
have this exact same drill . 25 years old and still going!!! no lie
Joshua S. Langford
Reviewed in the United States on June 22, 2016
Great tool at a great price. The one our company used for years was still going strong. The only reason we bought a new one was that the other one was stolen!
Beverley C.
Reviewed in the United States on December 22, 2014
It works well and get the job done
Kindle Customer
Reviewed in the United States on January 26, 2014
It's bullet proof! I am actually getting more work because I own this machine. Yesterday it took a 5 hr job and turned it into a 2 hr job! It's great and I am the envy of all. Plus! My back doesn't hurt and it's quieter then the Makita jack-hammer.
Robert Sowers
Reviewed in the United States on November 2, 2013
Meets all my expectations and then some. The capacity and quality of the product is awesome. I am not aware of any that exceed it!
Boyd
Reviewed in the United States on June 20, 2010
I bought one of these when they first came out (5+ years ago?) and have used it endlessly to drill 3" cored holes for pipe rail installations. Never gets hot. Never had a problem. A little heavy and tiresome to use but I guess it comes with the territory. It was rated as the largest rotory hammer availible when I bought it and proves itself in use. If anything it is too heavy duty for smaller drills (less than a 1/2") as it just beats them to dust. But you can't go wrong here if power and dependability is what your after. And... it's $200 cheaper than it was those years ago.