Your cart is empty.
Your cart is empty.Made of alloy forged steel for long, durable service life. * Hardened to RC 56-60 and ground to ensure maximum accuracy. * Holders are for double end mills.
j ferguson
Reviewed in the United States on May 26, 2020
I used this as a milling cutter holder for my Craftsman Drill press. Obviously the precision of this tool holder is better than the drill press and probably more than enough for use in a conventional mill having a #2 Morse Taper. I may buy a couple more in other sizes.
Max Smith
Reviewed in the United States on October 20, 2016
Great product great service
Monty King
Reviewed in the United States on May 21, 2013
The end mill holder works as I had hoped. Very nice product. Strong durable. I am using the end mill holder on a Craftsman Drill Press.Monty
A. Blate
Reviewed in the United States on March 23, 2013
The end mill holder arrived quickly, nicely-packaged, and in perfect condition. There was a trace of oil on the taper, but certainly no heavy grease; it was ready for use after a few seconds with a paper towel.The run-out in the taper itself and the tool as a whole (measured at the shank of a 3/8" end mill) is indistinguishable from that of my machinery (and most tooling, for that matter). Certainly within 0.0005".The set screw (which engages with the flat in your end mill) is large and is a good fit in the corresponding hole.The internal tolerances are close enough that they have milled a small hole in the side to allow air to escape as you insert your tool bit -- absolutely no wiggle room at all.Given the price, and assuming this is an import, it has exceeded my expectations. I cannot predict its durability but, given the overall quality and attention to detail, I expect to get many years of good service out of this tool.
RWB
Reviewed in the United States on March 22, 2013
Unit arrived on the 22nd, not the 28th as expected, good packaging & better looking than pictured. Price with shipping was good and being that it was the only M2 w/tang 3/8" end mill holder not on Chinese backorder, I now have a full set of near obsolete M2 style holders. It is very well balanced to 5500 rpm (highest speed I run) with a Weldon single end, double flute on tempered aluminum (WWII Vintage). Total run out is 0.0002". Unit was made in Poland, not China - I will do business with this company again.
Recommended Products
