Shopping Cart

Your cart is empty.

Your cart is empty.

Pro-Wrap Extra Large | Pack of 2 | Fits 7x7” to 8x8' Square and 8” to 10' Round Posts | Fence Protector | Dual-Layer Rot Protector | Wood Protector | 20-Year Guarantee

Free shipping on orders over $29.99

$28.45

$ 12 .99 $12.99

In Stock
  • THE ULTIMATE CHOICE - Postsaver Pro-Wrap’s are an innovative rot protection system that's totally unique. Proven & independently tested by the AWPA, this fence cover provides 100% rot protection to wooden posts & impressively extends their life by 20 years. Over 10M+ sold!
  • DUAL-LAYER ROT PREVENTION TECHNOLOGY - This fence protector utilizes a dual-barrier system that creates a water & airtight seal to the post. This seal then permanently locks out moisture, oxygen & fungi, the primary causes of post decay.
  • EASY APPLICATION - This post protection sleeve fits 7 x 7” to 8 x 8" (175x175mm to 200x200mm) square and 8 to 10" (200 to 250mm) round posts. Simply wrap around the post’s ground-line, apply heat using a hot air gun or gas blowtorch & it’s ready to install! Be sure to check the package for simple instructions.
  • 20-YEAR GUARANTEE - Postsaver's Pro-Wrap wood protectors are independently tested by the BRE with over 25+ years of outstanding results! Postsaver offers a 20-year post replacement guarantee on any UC4 timber post with our wrap applied correctly.
  • 26 YEARS OF INNOVATION & HERITAGE - Founded on years of extensive developement and testing, Postsaver is committed to creating premium products that make fencing easier, faster, and longer-lasting, ensuring long-life posts & hassle-free installation + maintenance.
  • WORKS WITH CONCRETE - All posts with Pro-Wrap rot protectors applied can be installed and set with fence post concrete



Product Description

lawn care
post support
fence cover
garden fencing ideas
lawn protector
fence accessory
  • Yes. All posts with rot protection applied to them can be installed with concrete post mix, fence post foam and can also be power driven into the ground without issue.

  • Rot protectors create an air and watertight seal around the critical first 6" below ground. This dual-layer rot protection seal system excludes all the factors required for decay to occur (oxygen, fungi and moisture), guaranteeing against rot.

  • Our confidence comes from our zero failure, 20-year independent field test data conducted by the BRE, Europe's largest and leading timber test organisation.

  • You need a high-powered (2+ KW) heat gun or a gas blow torch with a non pencil-tip flame. If applying rot protectors to a square post, you'll also need a foam roller to ensure adhesion to the flat sides of the post.

  • Below the first 6 inches in the ground, there is not enough oxygen for the fungi required for decay to survive; this means there is no need to protect the post below this point.


CB
Reviewed in the United States on August 5, 2024
Have it 5 stars because it came with clear instructions— I used a hair blow dryer to shrink wrap it around my poles, as it is all I had.
Julio Villanueva
Reviewed in the United States on October 21, 2024
I installed these sleeves on 4 posts. I messed the first one due to my inexperience. Make sure to apply the torch from far (12-16" away) and don't stop on one spot, keep the flame moving as if you were using a paint sprayer.It melts fast. After the first try the rest is easy to install.I hope it gives a good protection for 20-30 years at least. I'll probably won't be around by then to confirm, though. 😄Although the instructions recommend to wrap just part of it, I went the extra mile (and money) and wrapped the entire buried area. Why not.From now on I'll use these sleeves for any project where lumber is buried✌️✌️
Recommended Products