Your cart is empty.
Your cart is empty.Product Description
Project Pro: Ready to Use in Just 3 Steps!
Step 1
Attach Project Pro to drill/driver by inserting hex shaft into chuck, adjusting and tightening arm, and tightening battery strap.
Step 2
Insert the collated strip, pointed end first.
Step 3
Ensure drill/driver is set to FWD, press trigger and push down to drive screws Countersink depth can be adjusted using the depth-of-drive adjustment dial.
What Sets It Apart
Fast Performance, Every Time
Auto-feed technology drives screws repeatedly – just point and drive
Works with Your Tools
Works with most cordless drill or driver motors
Easy for Everyone
Simple to use – less experienced users can work quickly and efficiently
Keep Screws Right Where You Want Them
No fumbling and dropping screws
Compatible with Most Cordless Drills
dave
Reviewed in the United States on May 7, 2025
is a easy to use tool
KEVIN
Reviewed in the United States on May 24, 2025
Love it, wish I had this years ago.
Heartland Construction
Reviewed in the United States on May 14, 2025
Does not feed properly. Poor piece of equipment.
Janet & Dennis
Reviewed in the United States on April 18, 2025
This is a back and knee saver. I'm 72 and I like to do as much as I can rather than give my money someone else. I recently put new deck board on a 8x40' deck. I dreaded getting up and down to put over 1100 screws in place. I have had a few motorcycle accidents resulting in multiple broken bones, 2 back surgeries, fractured pelvis and hip along with other booboos. I would recommend this system to anyone doing this kind of project. WELL WORTH THE COST and it worked well. May never use it again but that's OK. My wife says thanks too.
Customer
Reviewed in the United States on April 18, 2025
It works very well
Recommended Products