Your cart is empty.
Your cart is empty.Spectre's polished aluminum air inlet has a 3 1/2 outside diameter on one end and the other end connects to applications with a stock LT1 inlet. Its 90 degree bend is fabricated from polished cast aluminum. It is designed to be used with a GM MAF sensor. It comes complete with boots, clamps and grommets.
KC
Reviewed in the United States on May 14, 2025
Real nice,I added a few more pieces to it..
Russ
Reviewed in the United States on June 26, 2023
Easy to install, but won't fit with stock air box without modification. I also installed the K&N air box, and I also had to modify that to fit. Looks great.
Phil
Reviewed in Canada on February 7, 2023
The Elbow itself is cool, and okay quality. Like other reviews stated, the rubbers were poor, and quite honestly unusable. They shorted me two clamps, but really no loss, they were junk. Is the elbow what I wanted? For sure, but be prepared to spend another $40 for the rubbers and clamps.
Chris Cameron
Reviewed in Canada on May 30, 2022
Hose connector for big end won't seal and clamps really poor quality and will strip out trying to seal. Smaller end would work but really hard and poor quality as well. Actual finish on tube had lots of scratches from shipping. Any one interested in purchasing this product should be prepared to spend another $100 on hoses and clamps to use this product!!
martial fillion
Reviewed in Canada on December 18, 2021
good
EB
Reviewed in Canada on December 10, 2020
The chrome was totally scratch from the hose clamps that were just tossed in the box and beat the crap out of it,
Evan M. Cox
Reviewed in the United States on May 31, 2019
Good part. For an old lt1. Only issue is the couplers...they are hard rubber and very hard to get a good seal.
Customer
Reviewed in the United States on November 13, 2017
PERFECT
Patrick
Reviewed in the United States on March 19, 2015
Fitment between the rubber hose was bad. causes many air gaps The product was poorly constructed. Finish inside the aluminum piece was terrible. The hose clamps provided won't close the 3/4 inch gap between the aluminum piece and the rubber fitting.
Tom Dupre
Reviewed in the United States on August 24, 2011
The elbow I received was very well finished on the outside. The grommet set was missing but a call to Spectre took care of that. Overall I'm satisfied with it
Recommended Products
