Your cart is empty.
Your cart is empty.Product Description
UCTRONICS NUC Rack Mount is designed to accommodate three NUCs, the standard 19inch 1U size can perfectly fit the 19-inch server rack. The perfect solution to optimize your workbench. It has three empty sockets and can install USB3.0/HDMI/Blank Keystone.
luis carlos serrano
Reviewed in the United States on January 7, 2025
cumple con lo especificado en la descipción
D. Bennett
Reviewed in the United States on January 20, 2025
The product is well-made and sturdy. The customer service is excellent. After messaging the seller they replied literally within minutes! I would absolutely buy from UTRONICS again.
Griffin
Reviewed in the United States on April 29, 2025
Just because its a niche produce does not mean it should be as expensive as it is. It fits everything but is very flimsy when you get three nucs mounted. I would recommend only if you're ocd like me and need your rack tidy.
Samuel D. Self
Reviewed in the United States on September 7, 2022
Came with the screws as shown. The metal seems 1/3 of the thickness as regular 19" rack hardware. It fits and works but I suspect 3 NUCs would sag a bit unless you had something below it for extra support.
Kyle
Reviewed in the United States on August 5, 2022
It holds my 3 nucs, but just feels flimsy. Wish there was both a bar at the back or expanded tray to add some support and mount my power supplies plus have a type of injection mold surrounding the inner face to keep the units in place. With 1 screw holding bonding the 2 units, it's easy to move when working on. Hope another iteration or design change adds some more stability and placement of power supplies.
Maverick
Reviewed in the United States on February 5, 2022
The rack mount chassis allows you to get your Intel NUC's off of a shelf and rack mount them.Since the NUC is held in place with a single screw at the center, the NUC can pivot side to side when you're connecting the network cable, power or other device. I would have preferred if this chassis was constructed so that it was a little deeper and had a piece metal that ran along either side of each NUC. That would hold the NUC in place more securely.You'll also notice that the NUC can bow up and down if touched even slightly if nothing is mounted immediately below this chassis. For this reason, I moved another server and mounted it right below this chassis.If you want to mount the NUC's with the back of the NUC to the front, as I have, you'll have to route power and the network cable to the front of the rack. One way to do this is with a 1U cable management insert. Given the small number of cables, I didn't want to take up 1U for that purpose. So I ran the power and network cables through the keystone jack insert, as you'll note in the picture. But I may give in and add the 1U cable management insert and route power and network through that opening.Overall, I'm happy with this rack mount chassis. I hope UCTRONICS iterates on this design and makes the next revision of this chassis a little deeper with rails on either side of the NUC as I described.
Recommended Products