Your cart is empty.
Your cart is empty.Great Product
Boater
Reviewed in the United States on July 25, 2020
I was surprised to find the product did not come with screws. Stainless steel screws are not cheap so I have to incur additional expense to install them.
randy
Reviewed in the United States on August 10, 2015
Difficult to install because you need cleat like these in hard to reach from behind areas in boat but if you can get it installed they work fantastic
North Georgia Hawg
Reviewed in the United States on July 6, 2015
I bought these to put on our boat, and I installed them in the big holes left from when I removed the butt-ugly Roswell Area 51 wake tower that had been on the boat when we bought it. They work very well for tying on docking fenders.
Brittany
Reviewed in the United States on December 2, 2015
Had ben looking at pop up cleats for a while. This is a great alernative if all you are wanting to do is hang a bumper.
Gerald Burke
Reviewed in the United States on October 22, 2015
Since there is a snap ring used it is necessary to have access to both sides of the surface you're mounting on. Other than that great looking and very useful.
Steve
Reviewed in the United States on April 2, 2013
I own two different brands. This one could take a lesson from the first ones. They need a hole through the top for a screwdriver. Otherwise you need a very small right angle screwdriver, or you need to remove the C clip, spring and top part. This is not easily done if it is hard to get your hands inside the hull. Otherwise, after instillation these cleats are great. All PWC's should come with these installed.
Zoe
Reviewed in the United States on June 10, 2011
These are great for our ski boat since the boat doesn't have cleats. They are small enough that they don't stand out too much. Would recommend.
Recommended Products
