Your cart is empty.
Your cart is empty.Set includes a wiggler chuck to hold ball contact, disc contact & needle point attachments and an offset indicator holder. Very useful item for locating application points on milling & other machines.Use to check run-out or concentricity, establish centres, check straightness or alignment of flat surfaces. Includes: chuck holder, needle point, 0.25" dia ball, 0.1" dia disc and offset indicator holder. Comes in a beautiful Pauch packaging
jwzumwalt
Reviewed in the United States on February 2, 2024
The best price I could find and the quality is 7 out of 10, well worth it
Customer
Reviewed in the United States on August 22, 2022
A rusty mess - returned.
Shirley L Moellentine
Reviewed in the United States on December 17, 2021
Arbor needed spreading to fit ball ends but works fine. Very nice kit.
Rick W.
Reviewed in the United States on December 13, 2021
Works great.
History Buff
Reviewed in the United States on January 25, 2021
This is a nice little set. I used the pointer and edge finder bit right away and both functioned fine. The set was drowning in oil so no rust! Not as fancy as a Starrett set but great for the price.
Margaret L Cochran
Reviewed in the United States on September 20, 2020
They are not the best quality, but they work and worth getting. You get what you pay for and if you are looking for a high end tool, this is not it, but if you are looking for something to get the job done for reasonable money, these are fine.
David Sees
Reviewed in the United States on September 1, 2020
I am using this on a cnc mill. The .100 tip is actually. 118 in diameter.
R M
Reviewed in the United States on June 5, 2020
Standard style wiggler chuck and attachments. Disappointed that they were all covered with rust. A light coat of oil would have saved a half hour of cleaning off the rust.
Recommended Products
$69.99
$ 32 .99 $32.99
$43.99
$ 22 .99 $22.99