Your cart is empty.
Your cart is empty.Product Description
Wind Turbine Generator: Renewable Energy Solution
Harness the power of the wind with our efficient and durable wind turbine generator. Designed for optimal performance, it features an intelligent control system and aerodynamic design to maximize energy output.
Description
This 600W wind turbine generator kit includes a wind turbine, anemometer, controller, 8 blades, and other accessories, providing you with a powerful tool to help generate electricity through wind. It features high quality, high efficiency, and strong performance that contributes to the annual power generation. It's worth trying!
Anemometer
The equipped anemometer with MODE&SET buttons, a six-blade wind wheel, and a thermal probe allows for accurate wind speed measurement. And it's anti-slip rope ensures convenient carrying.
Built-in Copper Insert
The copper insert won't damage the nylon fiber material when the bolt is tightened.
Flange Connection
The flange connection allows for a stable and firm connection between the wind turbine and the tower tube(excluded), making it safer to use.
Round Edge
The round edge of the blades and generator prevents your hands from scratching during installation.
How to Install
1. Take out the wind turbine, put it on the tower, and align it with the flange holes. Install four flat washers on the four bolts, and then insert the bolts into the corresponding holes of the flange. Tighten the screws with an Allen key.
2. The three wires of the wind turbine are connected with the transmission cable, each pair of wires is not less than 30mm, and the adhesive tape at the connection end is 100mm.
3. Connect the wind turbine cable to the controller. The battery must be connected to the controller before wiring.
Package Included
- 1* Wind Turbine
- 8* Blades
- 1* Wind Wheel
- 1* Controller
- 1* Anemometer
- 1* Flange Plate
- 1* English Manual
Working Temperature: -40 ~ 80 ℃/-40-176℉
Noise: 40db
Blade Length(Each): 40cm/15.7inch
Blade Diameter(Wheel Included): 92cm/36.22inch
Tower Tube Diameter: 42-45mm/1.65-1.77inch(Not Included)
Specifications
Voltage: 12V
Rated Power: 600W
Max. Power: 650W
Start-up Wind Speed: 3m/s
Rated Wind Speed: 13m/s
Safe Wind Speed: 50m/s
Max. Wind Speed: 60m/s
Notes
- This package does not include a tower tube, and we recommend using a steel pipe or iron pipe of 1.65-1.77" in diameter.
- The wind turbine should be installed where there is strong wind or without tall buildings and obstacles. If installing it near the obstacles, the position is better as far as possible from obstructions, or the installation height should be 20ft higher than the top of obstructions, which can make full use of the wind power. It should avoid the cliff and the turbulent region.
- The power of the wind turbine will increase with the wind speed. When the wind speed is very low, the wind wheel of the wind turbine will remain stationary. When the cut-in wind speed is reached (usually 3m/s), the wind wheel starts to rotate and the generator starts to generate electricity. As the wind becomes stronger, the output power will increase. When the wind speed reaches the rated wind speed, the wind turbine will output its rated power. After that, the output power will remain roughly unchanged. When the wind speed increases further and reaches the cut-out wind speed, the wind turbine will brake without power output to avoid damage.
- Please allow the slight color difference caused by the shooting light and 1-3cm error due to manual measurement, and make sure you do not mind before you order.
Kindle Customer
Reviewed in the United States on February 19, 2025
After running the turbine for 3 or so months the center hub for the blades came apart making the turbine absolutely useless.
Recommended Products