Shopping Cart

Your cart is empty.

Your cart is empty.

2pcs 2.5' to 3.5' Hard Drive Tray Holder for PCI SSD HDD Metal Mounting Bracket Adapter for PC Case Bottom Without Motherboard

4.9 (5) Write Review
Free shipping on orders over $29.99

$7.59

$ 3 .99 $3.99

In Stock

About this item

  • 2.5" to 3.5" Hard Disk Drive Tray (Full Height), each bracket adapter can hold one 2.5" hard drive and one 3.5" hard drive.
  • Suitable for computer cases with no motherboard at the bottom.
  • Package Content: 2pcs 2.5" to 3.5" Hard Disk Drive Tray, 10pcs x 6-32 Screws, 8pcs x M3 Screws (Flat Head).


2pcs 2.5" to 3.5" Hard Drive Tray Holder for PCI SSD HDD Metal Mounting Bracket Adapter for PC, Installation Suggestions: 1. Interval installation. The mainboard cannot be installed at the bottom of the chassis. 2. Horizontal placement: Because it is fixedwith a single screw, it can effectively solve the problem of heavy force on the hard disk. 3. Vertical placement: Place the bottom of the motherboard and fix it with EVA cushion.


Wolf
Reviewed in Australia on August 17, 2024
These Bracket Mounts are only Suitable for SSD HDDs as any IDE HDD's makes them Sag and Bend because the Brackets are not welded in both corners to Support Heavier IDE HDD's.
Jacob C. Dietz
Reviewed in the United States on June 24, 2024
Not much to say about something like this... was adding another drive to my son's gaming rig, and realized that we didn't have any drive trays. Ordered these up, and installed the drive loose so he could get going with it, but the very next these arrived, and we put them in. They fit as expected, and the included hardware was a nice bonus as we were missing a screw and needed them!
Jan B.
Reviewed in the United States on June 12, 2024
This bracket is well engineered and does fit correctly. Beware that you have to have bracket slots where there is no motherboard next to it. I did not pay close enough attention to the description and I tried to use this in a build with an MSI Z790 Edge Wifi in a Musetex mid-tower case. The bracket will not work because of all the M2 and PCIE slot risers. Might work if I had a mini-ATX board or a full tower with bracket slots that extend below the bottom of the motherboard.
User537983
Reviewed in the United States on October 27, 2024
Use this to put a hard drive in an empty PCI riser slot. By removing the riser board, it allowed this to fit inside a server.
TAZMDVL
Reviewed in the United States on December 8, 2023
I re-engineered these rear slot drive holders with another product to make a SSD hard drive slot. Nothing on the market like it so I built my own.