Your cart is empty.
Your cart is empty.Speedway spun aluminum coolant overflow expansion tanks weigh 50% less than other models. Ideal for filling radiator when level is low. Cap not included. AN 8 inlet & outlet. 40 oz. capacity. Bracket not included. Bracket 91032880 is sold separately and can be welded to the tank, strapped to the tank with hose clamps, or custom-mounted to suit your needs. Learn more about cooling with recovery systems and how they work by reading our tech article. Cooling System Principles. Please consider and make use of the following fittings that are available to utilize with this tank when a different (lower tank fitting only) AN size fitting is required for your specific application: 617-6180 AN12 to AN6. 617-6182 AN12 to AN10. 617-6184 AN12 to AN16. 617-6038 AN12 to AN12.
DunerJim
Reviewed in the United States on December 31, 2023
Sromewhat hard to find locally, or even on line. Exactly what I needed.
Dan Bordeau
Reviewed in the United States on June 23, 2022
Theres no CLEAR documentation about what an fittings are on this thing. The side port is 8an and the bottom is m22x1.5 orb to 8an that is basically just grey siliconed with no o-ring. Consider this when you buy. It looks and feels solid, and happens to fit almost perfectly in an $11 2lb fire extinguisher bracket if installed upside down. The overflow is a 1/8 npt as well. Going to use this for a GM LS degas tank. If you do, make sure to install a 0 psi radiator cap on your radiator (or remove just the little round recovery valve disc) and plumb the steam port and radiator overflow to the side port of this tank. The bottom port will tee into the front 3/4” heater hose. It will make filling it 1000x easier and there's NO bleeding procedure needed if you install it like this. Use a standard 16psi cap on this tank and run a small piece of hose from overflow to ubder the car. It will keep the engine cool, and make your heater blow fire when it gets cold outside again. :)
J. Chapple
Reviewed in the United States on May 8, 2022
Very high quality reservoir, & what they need to include in the listing is that the bottom fitting is an M24x1.5 thread. The reservoir is exactly as expected, but if I were to be picky a smaller rad cap neck would have been preferred (it is a full size type-A neck), and I wish the side fitting was threaded like the bottom so I could replace the 8an flare with another size. (I had to use an adapter for a 10an connection) As-is it’s still worth a 5-star rating!
Jim Babbs
Reviewed in the United States on January 14, 2019
Works good, good value
Recommended Products
