Your cart is empty.
Your cart is empty.Kp
Reviewed in the United States on April 3, 2025
The product seems fine correct size etc.. However, it is packaged poorly. There are 3 tie wraps around the product that must be removed and when you do this it can quickly turn into a big, tangled mess. Needs to be put on a spool or inside a small box where the user can pull it out without tangles!
POCONO PANDA
Reviewed in the United States on April 13, 2025
great seller and product is top shelf , you get exactly what you pay for here
Patricia
Reviewed in the United States on July 22, 2024
It works good with my weed eater
Sherry
Reviewed in the United States on May 4, 2024
Nice to have a line that is durable and enough to last without running to the store.
Kaylee Two
Reviewed in the United States on March 30, 2024
Trimmer Line.Does what it needs to.Way cheaper than buying it at a local store.Will buy again.
Jon D Wetherill
Reviewed in the United States on October 2, 2024
The trimmer line itself is fine. Seems reasonably durable. However, it doesn't come on any kind of spool. Just coiled up in the package. So inevitably became tangled when try to use it. As soon as you try to pull some out to put on the trimmer, it becomes tangled. So now, every time I use it I have to untangle a bunch of it before I can use it, which it quite time consuming. Awful.
Glendora
Reviewed in the United States on October 13, 2023
The stock reel was terrible. This line is far more durable for my 18v ryobi.
darco
Reviewed in the United States on December 15, 2022
I'm sure this stuff works great in a weed trimmer, but I'm using this for 3D printing.Using trimmer line as a 3D printing filament requires at least 24 hours in a 70°C dehydrator before it is printable. You also need to put the stuff on a spool, which is... Painful.But after all that, it does seem printable. With a nice Fuchsia color, too. But I noticed that this trimmer line has some different properties compared to most other trimmer lines I've printed with:* It is significantly harder. Most other trimmer lines print out with a relatively flexible part. This stuff prints out way harder, more similar to PETG.* It likes to be printed hot (270°C), especially the first few layers (after which you can lower it down to 260°C).* It warps a lot, WAY more than the other trimmer lines I have printed with, so unless you are printing very small parts or don't mind the warp, you will need an enclosure.I'm glad to have this stuff in my filament box since it has unique properties that I haven't found in any other filament in it's price range, but it is a little tricky to print without warping.But, hey, I can't hold that against it. Five stars for value. There is some confusion on the Amazon description, as it seems to indicate that the length is 960', which seems a bit longer than what other filaments sell as "one pound". That's a huge change in density, but I haven't measured it yet. Just be aware, you are likely either getting a bit more than a pound, or you are likely getting a bit less than 960'.
Recommended Products
