Your cart is empty.
Your cart is empty.Jesse
Reviewed in the United States on August 27, 2024
Used on my 24v cummins. Works but the signal isn't consistent (will be at 30 psi, then drop to 0 then back to 30) so causes truck to derate erratically.
Aaron
Reviewed in the United States on August 19, 2024
It’s smaller than the OEM map sensor in terms of the opening , and socket size required. This will take a 27mm deep socket to install; while the OEM was a 32mm socket.Overall this MAP sensor fixed my turbo overboost code and was simple to install. Make sure to swap the gasket from the original MAP sensor connector to this one.Will update this if I remember or if I have problems with the sensor.
Jake
Reviewed in the United States on March 4, 2024
Unfortunately it is too late to return it and its now showing constant 45-47psi of boost at idle. Did not last long at all.
M. D.
Reviewed in the United States on February 24, 2024
I had low turbo boost code on dodge diesel. Easy installation and a quick fix.
Shawn C.
Reviewed in the United States on September 13, 2021
Replaced this sensor on my motor home diesel engine. My old sensor wasn't reporting pressure. I installed this new sensor and now have reported pressure. It fit perfect into the engine but the socket size is small than the original sensor I took off, the wire plug is the same. Happy so far
Ran
Reviewed in the United States on November 2, 2021
Map sensor was shorted out. I was lucky it didn't burn my ecm. I paid for the Napa sensor and the truck runs great now.
Jacimi
Reviewed in the United States on September 14, 2020
Been running this about 2 months now, works great!
Elaine Lowe
Reviewed in the United States on September 28, 2019
Fast shipping. Fixed my MAP code. Truck seems to be back to its normally.
Recommended Products
