Your cart is empty.
Your cart is empty.OTC's Steering Head Bearing Installer for Harley-Davidson motorcycles is designed to install steering head bearing cups and races - completely straight - without any damage to components. Works on stock and custom applications. Crafted from high-grade materials to ensure quality performance over the lifetime of the tool. Similar to HD-39302. Value is at the core of the OTC tool and equipment portfolio. For a simple repair or the most complex drivability concern, these award-winning tools universally solve problems faster, and at better value, than any other product line available. Whether it’s a specialty tool or unique piece of service equipment, OTC provides top solutions to modern automotive service challenges while increasing technicians’ productivity and shop profits.
Some guy
Reviewed in the United States on April 1, 2025
Worked great for seating neck race cups on the steering stem for a 1993 Harley Dyna. The races weren't seating straight at first, so I threw them in the freezer overnight. When I was ready to install the race, I heated up the neck on the bike with a heat gun until the metal was around 250°, set the race on the edge, and then used this tool to pull the races and fully seat. Worked like a champ.The tool is built well and plenty strong.
Siska cycles
Reviewed in Canada on May 29, 2024
Good quality
Alma
Reviewed in the United States on May 14, 2023
Works great as described
Customer
Reviewed in the United States on February 9, 2022
Do not buy. The race drivers do not fit into the race so that the driver lip seats on the face of the race. Because it does not fit all the way in and seat on the face, the race does not sit evenly and tilts on the driver. Yes this was for the proper size race, the difference is minimal but significant enough to cause the race to be driven crooked every time. This tool is trash.
Customer
Reviewed in Canada on January 26, 2022
It was very difficult to square up the outer race to press in took several attempts when it was almost in the bolt snapped and shot out the top of the neck
joe
Reviewed in the United States on April 17, 2022
For the brand I was a little disappointed in the nut being weak and threads on shaft seem to pull if not careful
Dave B
Reviewed in Canada on September 2, 2021
The angle was off several degrees for the bearing cups for my Harley
Neal L.
Reviewed in the United States on August 6, 2020
Can install them both at the same time and take your time with them and get them right.
Kevin N.
Reviewed in the United States on December 5, 2019
Worked like a charm.
Tytus
Reviewed in the United States on April 3, 2019
Worked fine. Always use set tool, you'll regret if you don't.
Robert E.
Reviewed in the United States on June 20, 2018
Worked perfectly for pressing the bearings in to the steering head of my 2012 XL1200
Mr. P90, Ms. H&K
Reviewed in Canada on May 6, 2016
Sort of worked on the Harley, no real support or guide to keep them going in straight & constantly tried twisting, ended up grinding diameter of original races down and welding a shaft to them to drive the new ones in straight. I'd recommend something else, total waste of money.
Recommended Products
$71.40
$ 33 .99 $33.99