Shopping Cart

Your cart is empty.

Your cart is empty.

RBI125F Rain Barrel Inlet Buttress Adapter(2' Fine Thread Bung Cap to 1-1/4' Barbed Fitting)

Free shipping on orders over $29.99

$7.95

$ 2 .99 $2.99

In Stock



Product Description

RAINPAL(by OLDEGG USA) Designing Quality Rain Barrel Parts Since 2013

RAINPAL Products
SDB125

Matching Step Drill Bit Available: RAINPAL SDB125 a.co/d/iQ30Gv7

Three large steps(7/8", 1-1/16" and 1-1/4")(8mm Height), works for most RAINPAL Products.

For RAINPAL SSBF020, Please use the 2nd step(1-1/16")

Step drill bit makes cleaner hole with no or minimum burs.

Use with power drill for more control. Impact drive will be too aggressive.

Designed to use on Plastics. Will not last long on steel.

Click "Visit the RAINPAL Store" then "FITTING_ETC" to purchase or use this link: a.co/d/iQ30Gv7


E.W.
Reviewed in the United States on July 28, 2020
Bought one for my water storage barrel and it has developed a small pin hole leak at the point where the spout starts. Very small and slow leak. I keep my water storage outside so it's not much of an issue. The temp has never gone below 40F since it was installed and the leak has just begun in the last couple months since it has been hot out.
Gary K
Reviewed in the United States on June 20, 2019
I used this with a blue barrel, but it should work fine with any barrel that has fine threads. That's important, as most barrels have 2 bung holes, 1 will be fine thread, and the other hole will be coarse, or (in barrel-speak) a buttress thread.If you make your rain water catch system like I did, you'll use the fine threaded holes for the PVC pipe to connect 2 barrels, so you'll be left with a buttress thread for the water inlet - which is what this is for. So you'll need to find a 2 inch buttress thread to fine thread adapter to make it work. (I used this one: https://www.amazon.com/gp/product/B00MWYLOA2/ref=ppx_yo_dt_b_asin_title_o08_s00?ie=UTF8&psc=1)I've attached a few pictures that hopefully make it easier to understand how I made my system. 2 inch PVC to connect the barrels, the spigot fit into the lower buttress thread cap, and this (with an adapter) fit into the top.
Cam
Reviewed in the United States on September 11, 2018
Awesome product.
Technical Squirrel
Reviewed in the United States on July 24, 2018
Perfect, just what I needed....
DONALD
Reviewed in the United States on March 17, 2018
GREAT
Dave Slayton
Reviewed in the United States on December 7, 2018
Worked like a charm. Planning on putting another rain barrel in next spring. I will definitely buy again.
Beastwhite
Reviewed in the United States on November 20, 2018
Works like a charm, although I ended up not needing it for my rain barrel setup
filas
Reviewed in the United States on July 31, 2017
It screwed into my rain barrel bung perfectly. Worked great.