Shopping Cart

Your cart is empty.

Your cart is empty.

Ladder Jacks Bracket Extension - Adjustable Extension Scaffold Ladder Jack 2 Pack for Working 20 inch Stage

4.5 (6) Write Review
Free shipping on orders over $29.99

$93.99

$ 45 .99 $45.99

In Stock

About this item

  • Ladder jack 2pcs can be mounted on top of 2 telescoping ladders. Creates a 21-inch platform allowing us to work at height.
  • Material is made of high quality aluminum alloy material. Can withstand up to 250 lbs. Make the built up platform more solid and reliable.
  • When you need the right angle and position. You just need to solve it by adjusting the position of the bracket and screws.
  • Ladder jacks are ideal for overhead workers. It is used for painting siding, roofing, window repair, etc. And easy to install and carry.
  • The ladder jacks are all under strict quality control by the factory. If you have any operation and quality problems. Please contact me. I will give you a satisfactory reply within 12 hours.


Yzzwer Ladder jack mounts between two rungs. Often used for overhead work use.


Features:

1: Easy to install

2: Strong load bearing

3: Safe and reliable


Yzzwer will always be with you during the long work and life. Making your job safer.


In order to bring you 100% service experience.

We have a full refund policy with six months free replacement and one year parts warranty policy.


If you have any questions you can contact us. We will respond to any questions you may have within 24 hours..


Francisco Javier García mendez
Reviewed in the United States on March 20, 2025
Muy buen trabjo
David J.
Reviewed in the United States on April 2, 2025
These are horrible and unsafe, completely bent after second use they are death waiting to happen and should not be sold
Hank Who Fell
Reviewed in the United States on July 3, 2024
Overall, these jacks are well made and should allow one many years of service. However, there are a couple of things that possibly got overlooked. They are not an "Aluminum Alloy" but stamped and welded steel. If you are using these near salt water, it will likely shorten the life. Most US ladders have rungs on 12 in center. The lower leg of the jack, which ideally would rest on the lower rung, ends up about 1/2 to 3/4 inch above it. It can be modified easily by drilling additional holes in the brace to fit it to the ladder. It can be used as is, but the entire load will be on the top brace.
Ken Jones
Reviewed in the United States on November 9, 2024
This product failed, and almost caused severe harm while being used. It bent while I was on it up in the air on a scaffold plank. I would like my money back
DeltaV
Reviewed in the United States on November 17, 2024
Had to return this twice. Both times the parts were received with significant amounts of rust due to poor plating. Even the third set had some small spots which I was willing to live with.
Eric
Reviewed in the United States on October 28, 2024
One of the brackets collapsed under 190lbs of weight, my weight i fell from luckily only 8ft.I'm going to have to go get xrays of my knee now. The safety extra stopper/latch that helps hold the bracket in place bent through the light flimsy metal slot resulting in a fight with gravity.